Common Symptoms
- Check Engine Light illuminated
- Engine runs rough or misfires
- Hard starting or extended cranking
- Engine stalls intermittently
- Poor acceleration or hesitation
- Reduced fuel economy
Most Likely Root Causes
- Faulty camshaft position sensor
- Damaged or corroded sensor wiring harness
- Poor electrical connection at sensor connector
- Timing chain or belt out of specification
- Failed engine control module
Full step-by-step tests, DVOM guidance, and pinout data are available inside the AI Diesel Tech diagnostic session.
AI walks you through every test — one step at a time. Plans start at $12.95/mo.
Component Location
The camshaft position sensor on Bank 2 is typically located near the cylinder head on the side opposite the Bank 1 sensor.
Manufacturer Notes
Some V6 and V8 engines may require specific sensor relearn procedures after replacement to ensure proper signal recognition.
Also diagnosing J1939 SPN/FMI codes?
Heavy-duty trucks often throw both OBD-II and J1939 faults simultaneously. AI Diesel Tech handles both protocols in a single guided session.
AI Diesel Tech — The Technician's Diagnostic Engine
AI Diesel Tech diagnostic logic is built by an ASE Certified Diesel Technician. Professional-grade OBD-II and J1939 fault analysis — trusted by technicians nationwide, used in shops, fleets, and training programs.
Get AI-Guided Diagnosis for P0345
The diagnostic engine walks you through every physical test — step by step, on your phone, at the truck.