Camshaft Position Sensor A Circuit Intermittent (Bank 1)
Common Symptoms
- Check Engine Light illuminated
- Engine cranks but fails to start or starts with difficulty
- Rough idle or engine stalling at idle
- Poor acceleration or hesitation under load
- Engine misfires or runs unevenly
- Reduced fuel economy
Most Likely Root Causes
- Faulty or failing camshaft position sensor
- Damaged or corroded wiring harness or connector at sensor
- Intermittent electrical connection or loose connector
- Engine oil contamination on sensor tip affecting signal
- Timing chain or belt wear causing erratic sensor readings
Full step-by-step tests, DVOM guidance, and pinout data are available inside the AI Diesel Tech diagnostic session.
AI walks you through every test — one step at a time. Plans start at $12.95/mo.
Component Location
The camshaft position sensor is typically located near the front or rear of the cylinder head on Bank 1, close to the camshaft gear or timing cover.
Manufacturer Notes
Some manufacturers have updated sensor designs or connector seals to address intermittent signal issues related to heat or vibration exposure.
Also diagnosing J1939 SPN/FMI codes?
Heavy-duty trucks often throw both OBD-II and J1939 faults simultaneously. AI Diesel Tech handles both protocols in a single guided session.
AI Diesel Tech — The Technician's Diagnostic Engine
AI Diesel Tech diagnostic logic is built by an ASE Certified Diesel Technician. Professional-grade OBD-II and J1939 fault analysis — trusted by technicians nationwide, used in shops, fleets, and training programs.
Get AI-Guided Diagnosis for P0344
The diagnostic engine walks you through every physical test — step by step, on your phone, at the truck.